On 08.02.2024 12:14, gene heskett wrote:
gene@coyote:/etc$ sudo smartctl --all -dscsi /dev/sdm
smartctl 7.3 2022-02-28 r5338 [x86_64-linux-6.1.0-17-rt-amd64] (local
build)
Copyright (C) 2002-22, Bruce Allen, Christian Franke,
www.smartmontools.org
=== START OF INFORMATION SECTION ===
Vendor:
Product: SSD 3.0
Revision: 2.00
Compliance: SPC-2
User Capacity: 2,097,152,000,000 bytes [2.09 TB]
Logical block size: 512 bytes
scsiModePageOffset: response length too short, resp_len=4 offset=4
bd_len=0
scsiModePageOffset: response length too short, resp_len=4 offset=4
bd_len=0
>> Terminate command early due to bad response to IEC mode page
A mandatory SMART command failed: exiting. To continue, add one or
more '-T permissive' options.
gene@coyote:/etc$
And then again, it worked, sorta
Cheers, Gene Heskett, CET.
Looks like a scam. Probably a reprogrammed controller to falsely report
2TB of space to the system.
This is how I would test it.
First create a new GPT partition table and a new 2TB partition:
$ sudo gdisk /dev/sdX
/!\ Make double sure you've selected the right device by using "lsblk"
and "blkid" utilities. /!\
/!\ It could change from 'sdm' to another
name after reboot. /!\
At gdisk prompt press "o" to create a new GPT table, next press "n" to
create a new partition, accept default values by pressing "enter".
To verify setup press "p", to accept configuration and write it to
device press "w".
Next format partition to ext4 filesystem:
$ sudo mkfs.ext4 -m 0 -e remount-ro /dev/sdX1
Next mount the filesystem:
$ sudo mkdir /mnt/disktest
$ sudo mount /dev/sdX1 /mnt/disktest
Next create reference 1GB file filled with dummy data:
$ cd /mnt/disktest
$ sudo fallocate -l 1G ./reftestfile
$ sudo badblocks -w -s -t random ./reftestfile
Now we can use script to create 1830 1GB files and check their checksum:
$ for i in $(seq 1830); do sudo dd if="./reftestfile"
of="./testfile${i}" status=none; md5sum -b "./testfile${i}" ;done
This procedure will take a very long time to complete. "md5sum" will
output the checksum for each file and they should be equal to checksum
of "reftestfile":
$ md5sum -b ./reftestfile
3f2c5fa95492bfaa18f08c801037d80b *./reftestfile
$ for i in $(seq 1830); do sudo dd if="./reftestfile"
of="./testfile${i}" status=none; md5sum -b "./testfile${i}" ;done
3f2c5fa95492bfaa18f08c801037d80b *./testfile1
3f2c5fa95492bfaa18f08c801037d80b *./testfile2
...
3f2c5fa95492bfaa18f08c801037d80b *./testfile1830
Obviously, checksum for your "reftestfile" will be different from mine.
If 'for' loop fails at some point, you can count testfiles to see how
many of them were actually written to disk.