Re: how to specify kernel parameter "memmap="
On Mon, 2014-01-06 at 07:48 -0500, Long Wind wrote:
> knoppix CD doesn't seem to be able to boot
On Thu, 2014-01-09 at 09:23 +0800, Long Wind wrote:
> I'v try Knoppix, it can't run, I make no progress
What does it mean? You put the Knoppix CD/DVD into the drive and then
doesn't happen anything? Or does it start to boot and then doesn't
finish the boot process? If it does start booting, at what point does it
stop booting? Linux does show messages during the boot process and we
ask you several times to post those messages. We also told you what to
do, if you should see a picture instead of messages, then you need to
push the Esc-key or one of the F-Keys. Try one key after the other until
you see messages.
You could start troubleshooting by posting at least the last complete
message before booting stops.
On Thu, 2014-01-09 at 09:33 +0800, Long Wind wrote:
> today I plug the disk with woody to a P4/1.6G PC
> it can't boot though it can boot a P4/2.9G PC
You put another CPU into the same motherboard? You used another PC with
another motherboard with another chip set, graphics etc.?
> error msg are mainly about CPU
Is it a guessing game? Post the original complete error messages you
get. The "mainly about CPU" and the few others too.
Reply to: