Re: md: can not impport hdb1, has active inodes!
On Wednesday 03 March 2004 01:36, Chris Evans wrote:
> On 3 Mar 2004 at 10:40, Neil Brown wrote:
> > Wrong.
> > mkfs -t ext3 /dev/md0
> > then mount /dev/md0.
> > Once you have included /dev/hdc1 in an array, don't touch it again -
> > just access the array (/dev/md0).
>
> Sorry, I was being hasty in writing the Email, that's what I did,
> i.e. mkfs the /dev/md0 drive. That's not the problem.
Hope it's not too obvious, but...
Did you also actually _run_ lilo ?
Is fstab on /dev/md0 edited to reflect the new mountpoints ?
Not that it helps you here, but I followed the procedure -albeit not from the
same howto[1]- multiple times with many machines. It _should_ work...
[1] I used a howto by the name of Boot+root+raid+llilo. Maybe see if there
are any obvious differences between the two procedures / howtos...?
Maarten
Reply to: