[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#644906: [squeeze] e1000e: upstream workaround for packet drop on 82579LM at 100Mbps



severity 644906 important
tags 644906 + upstream patch fixed-upstream
found 644906 linux-2.6/2.6.32-39squeeze1
quit

Hi Holger,

Holger Jeromin wrote:

>> The patch ("e1000e: workaround for packet drop on 82579 at 100Mbps")
>> hit mainline in v3.1-rc4.  Are squeeze 2.6.32.y kernels affected?
>
> As you can see in my smokeping there is still a paket loss in my
> internal network:
> http://www.katur.de/smokeping/smokeping.cgi?target=Local.Telefon
>
> It would be nice, if you can fix the problem with a new kernel for
> squeeze, since the paket loss is not nice for VoIP-Calls :-)

Please test the attached patch, following instructions from [1].

Ben: it looks like there have been 31 commits to the e1000e driver
from 2.6.38 to 3.0.y.  The patches marked with '+' seem like
candidates for inclusion in squeeze.  '?' generally means I was
too lazy to think about that patch and it might or might not be a
candidate.  What do you think?

 - 67fd4fcb78a7 (convert to stats64) - no stats64 in squeeze.
 - 90da06692532 (reduce scope of some variables, [...]) - cleanup.
 - 05b9321405ef (Use kmemdup rather than duplicating its
   implementation) - cleanup.
 - 79f5e8401437 (replace unbounded sprintf with snprintf) - no-op,
   since interface names have length <= 15 by definition.
 - 5c1bda0aa32e (use correct pointer when memcpy'ing a 2-dimensional
   array) - cosmetic.
 ? 5962bc21ceaa (return appropriate errors for 'ethtool -r' when
   invoked while interface is not up or when auto-negotiation is
   disabled)
 ? ff938e43d39e (net: use pci_dev->revision, again).  Seems harmless.
 + ef5ab89cf7ed (use dev_kfree_skb_irq() instead of dev_kfree_skb())
 - d8d5f8aebb85 (magic number cleanup - ETH_ALEN) - cosmetic.
 + 5661aeb08edc (extend timeout for ethtool link test diagnostic)
 + 1effb45cca29 (extend EEE LPI timer to prevent dropped link)
 + 6cc7aaed70c9 (do not toggle LANPHYPC value bit when PHY reset is
   blocked)
 + 23e4f0613067 (disable jumbo frames on 82579 when MACsec enabled in
   EEPROM)
 + 4a29e15515ea (do not suggest the driver supports Wake-on-ARP)
 ? 70d279a7e2a6 (bump version number) - probably a good idea.  Would
   the lack of stats64 support confuse people?
 - aa3386015811 (PM: Remove CONFIG_PM_OPS) - already applied.
 - 25985edcedea (Fix common misspellings) - cosmetic.
 ? 1bba4386ab4f (convert short duration msleep() to usleep_range()) -
   requires 5e7f5a178b (introducing usleep_range timer) which is not
   in squeeze.
 + a5cc764206a3 (PCIe link speed in GT/s, not GB/s) - printk typofix
 - 86d70e532c35 (convert to new VLAN model) - no ETH_FLAG_TXVLAN in
   squeeze.
 - 2084b114e3fb (fix stats locking in e1000_watchdog_task) - no
   stats64 in squeeze.
 ? 78cd29d5a92a (If ASPM L0s needs to be disabled, do it prior to
   enabling device) - no effect except in nonstandard configurations,
   I think
 - dbf80dcbd8ca (implement ethtool set_phys_id) - no set_phys_id in
   squeeze.
 + 25db0338813a (Use full 32 bit speed range in ethtool's
   set_settings)
 - 707394972093 (cosmetic: Use ethtool ethtool_cmd_speed API) -
   cosmetic.
 + 14ad2513ed5b (more robust ethtool duplex/speed configuration)
 - d64a6f4dca0b (minor comment cleanups)
 ? 9f728f53dd70 (PCI/e1000e: Add and use pci_disable_link_state_locked())
 - 70c71606190e (Add appropriate <linux/prefetch.h> include for
   prefetch users) - not needed in squeeze.
 + 716ae31687f2 (alternate MAC address does not work on device id 0x1060)
 + 9202d3166127 (workaround for packet drop on 82579 at 100Mbps)

Hope that helps,
Jonathan

[1] http://kernel-handbook.alioth.debian.org/ch-common-tasks.html#s-common-official
or the corresponding page in the debian-kernel-handbook package
From: Bruce Allan <bruce.w.allan@intel.com>
Date: Fri, 29 Jul 2011 05:52:56 +0000
Subject: e1000e: workaround for packet drop on 82579 at 100Mbps

commit 0ed013e28fe853244f4972cf18d8e2bd62eeb8fc upstream.

The MAC can drop short packets when the PHY detects noise on the line at
100Mbps due to a timing issue.  Workaround the issue by increasing the PLL
counter so the PHY properly recognizes the synchronization pattern from the
MAC.

Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Jonathan Nieder <jrnieder@gmail.com>
---
 drivers/net/e1000e/ich8lan.c |   19 ++++++++++++++-----
 1 file changed, 14 insertions(+), 5 deletions(-)

diff --git a/drivers/net/e1000e/ich8lan.c b/drivers/net/e1000e/ich8lan.c
index fb46974cfec1..92812f439860 100644
--- a/drivers/net/e1000e/ich8lan.c
+++ b/drivers/net/e1000e/ich8lan.c
@@ -137,8 +137,9 @@
 #define HV_PM_CTRL		PHY_REG(770, 17)
 
 /* PHY Low Power Idle Control */
-#define I82579_LPI_CTRL			PHY_REG(772, 20)
-#define I82579_LPI_CTRL_ENABLE_MASK	0x6000
+#define I82579_LPI_CTRL				PHY_REG(772, 20)
+#define I82579_LPI_CTRL_ENABLE_MASK		0x6000
+#define I82579_LPI_CTRL_FORCE_PLL_LOCK_COUNT	0x80
 
 /* Strapping Option Register - RO */
 #define E1000_STRAP                     0x0000C
@@ -1596,6 +1597,7 @@ static s32 e1000_k1_workaround_lv(struct e1000_hw *hw)
 	s32 ret_val = 0;
 	u16 status_reg = 0;
 	u32 mac_reg;
+	u16 phy_reg;
 
 	if (hw->mac.type != e1000_pch2lan)
 		goto out;
@@ -1610,12 +1612,19 @@ static s32 e1000_k1_workaround_lv(struct e1000_hw *hw)
 		mac_reg = er32(FEXTNVM4);
 		mac_reg &= ~E1000_FEXTNVM4_BEACON_DURATION_MASK;
 
-		if (status_reg & HV_M_STATUS_SPEED_1000)
+		ret_val = e1e_rphy(hw, I82579_LPI_CTRL, &phy_reg);
+		if (ret_val)
+			goto out;
+
+		if (status_reg & HV_M_STATUS_SPEED_1000) {
 			mac_reg |= E1000_FEXTNVM4_BEACON_DURATION_8USEC;
-		else
+			phy_reg &= ~I82579_LPI_CTRL_FORCE_PLL_LOCK_COUNT;
+		} else {
 			mac_reg |= E1000_FEXTNVM4_BEACON_DURATION_16USEC;
-
+			phy_reg |= I82579_LPI_CTRL_FORCE_PLL_LOCK_COUNT;
+		}
 		ew32(FEXTNVM4, mac_reg);
+		ret_val = e1e_wphy(hw, I82579_LPI_CTRL, phy_reg);
 	}
 
 out:
-- 
1.7.9.2


Reply to: